| Author |
Message |
|
jsoar
|
Post subject: Series Rating a Panelboard.  Posted: Tue Aug 05, 2025 5:02 am |
|
Joined: Wed Jun 12, 2024 5:19 am
Posts: 35
|
|
Hello,
If I needed to series-rate a panelboard. Do I enter the rating of the breaker in the Series rating box under the component subview? I know in EasyPower I would select a check mark and it would pass on the device evaluation because it is still showing up as a fail on skm. Am I missing a step?
|
|
| Top |
|
 |
|
jsoar
|
Post subject: Re: Series Rating a Panelboard. Posted: Tue Aug 05, 2025 8:08 am |
|
Joined: Wed Jun 12, 2024 5:19 am
Posts: 35
|
|
Yes, but what about the device evaluation? is there a way to show it as passed because it is being series rated?
|
|
| Top |
|
|
|
bbaumer
|
Post subject: Re: Series Rating a Panelboard. Posted: Tue Aug 05, 2025 10:42 am |
|
| Arc Level |
 |
Joined: Fri Jul 08, 2016 10:01 am
Posts: 497
|
|
Mike is correct.
If you enter a series rating in the Component Editor for the device, or bus, and that rating is higher than the X/R adjusted, calculated available fault current, it will pass the Device Evaluation.
_________________
95% Retired
|
|
| Top |
|
|
 
|
Page 1 of 1
|
[ 3 posts ] |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
