| Author |
Message |
|
BGnan
|
Post subject: What electrode config to model bridge crane bus bar  Posted: Sun Dec 11, 2022 6:07 pm |
|
Joined: Tue Nov 04, 2014 5:53 am
Posts: 28
|
|
Any suggestions or experience modeling conductor bus bar / rail system used for mobile equipment - e.g. a hoist or bridge crane - see photo above.
Horizontal Electrodes in Open Air - HOA? Even though the a large percentage of the bus is insulated (but would melt away during an AF incident).
Thank you for your thoughts!
| Attachments: |
Conductor_Bar_2-updated.png [ 86.85 KiB | Viewed 15093 times ]
|
|
|
| Top |
|
 |
|
BGnan
|
Post subject: Re: What electrode config to model bridge crane bus bar Posted: Wed Dec 14, 2022 6:23 am |
|
Joined: Tue Nov 04, 2014 5:53 am
Posts: 28
|
|
And more importantly - what to do about there being no enclosure other than a back wall to focus/direct the energy?
|
|
| Top |
|
|
|
BGnan
|
Post subject: Re: What electrode config to model bridge crane bus bar Posted: Sun Dec 18, 2022 11:47 am |
|
Joined: Tue Nov 04, 2014 5:53 am
Posts: 28
|
|
I believe I was overthinking (or under-thinking) this - seems this is clearly a HOA application out of all the options.
|
|
| Top |
|
|
 
|
Page 1 of 1
|
[ 3 posts ] |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
