| Arc Flash Forum https://brainfiller.com/arcflashforum/ |
|
| What electrode config to model bridge crane bus bar https://brainfiller.com/arcflashforum/viewtopic.php?f=8&t=5641 |
Page 1 of 1 |
| Author: | BGnan [ Sun Dec 11, 2022 6:07 pm ] | ||
| Post subject: | What electrode config to model bridge crane bus bar | ||
Any suggestions or experience modeling conductor bus bar / rail system used for mobile equipment - e.g. a hoist or bridge crane - see photo above. Horizontal Electrodes in Open Air - HOA? Even though the a large percentage of the bus is insulated (but would melt away during an AF incident). Thank you for your thoughts!
|
|||
| Author: | BGnan [ Wed Dec 14, 2022 6:23 am ] |
| Post subject: | Re: What electrode config to model bridge crane bus bar |
And more importantly - what to do about there being no enclosure other than a back wall to focus/direct the energy? |
|
| Author: | BGnan [ Sun Dec 18, 2022 11:47 am ] |
| Post subject: | Re: What electrode config to model bridge crane bus bar |
I believe I was overthinking (or under-thinking) this - seems this is clearly a HOA application out of all the options. |
|
| Page 1 of 1 | All times are UTC - 7 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|